Difference between revisions of "Low-cost IMU"
From AIRWiki
m |
m |
||
| Line 19: | Line 19: | ||
* defining suitable calibration procedures for R2P_IMU; | * defining suitable calibration procedures for R2P_IMU; | ||
* testing the actual performance of the calibrated R2P_IMU; | * testing the actual performance of the calibrated R2P_IMU; | ||
| − | * exploring the possibility of processing the output of R2P_IMU (one or more units) | + | * exploring the possibility of processing the output of R2P_IMU (one or more units) borne by people to extract higher-level information about the behavior of the bearers. |
Revision as of 16:27, 22 November 2012
Low-cost IMU
| |
| Short Description: | Characterization of a low-cost IMU module developed by AIRLab; use of such module to extract high-level information about human behavior. |
| Coordinator: | MarioVerdicchio () |
| Tutor: | MartinoMigliavacca (migliavacca@elet.polimi.it), MatteoMatteucci (matteo.matteucci@polimi.it) |
| Collaborator: | |
| Students: | NguyenHo (nguyenho83@yahoo.com) |
| Research Area: | Robotics |
| Research Topic: | Robot development |
| Start: | 2012/11/01 |
| End: | 2013/12/31 |
| Status: | Active |
| Level: | Ms |
| Type: | Thesis |
This project is related to the ongoing effort of AIRLab in developing low-cost robotic modules and systems. An Inertial Measurement Unit based on MEMS sensors (called R2P_IMU) has already been designed and realized. This project has the objectives of:
- defining a model of R2P_IMU to enable its characterization;
- characterizing the output of R2P_IMU in correspondence to physical action;
- defining suitable calibration procedures for R2P_IMU;
- testing the actual performance of the calibrated R2P_IMU;
- exploring the possibility of processing the output of R2P_IMU (one or more units) borne by people to extract higher-level information about the behavior of the bearers.
